FINITE ELEMENT METHOD PARAMETERIZATION OF DEEP DRAWING PROCESS USING A CAD-CAE APPLICATION

  • Alin Pop University of Oradea
  • Ioan Radu University of Oradea
  • Florin Blaga University of Oradea
Keywords: deep drawing, finite element analysis, abaqus

Abstract

Finite element analysis is a time consuming process and cost. Optimization of the process and accuracy measurement is one of the most common objectives in our days. In this paper described an application CAD-CAE which aims to solve the problem of geometry regeneration where obtained measurements through the finite element analysis are not satisfying, and also aims to makes the process of defining boundary conditions and deep drawing forces implementation easier.

References

1. http://www.tu-chemnitz.de/projekt/abq_hilfe/docs/v6.12/books/gsa/default.htm
2. Ayari, T. Lazghab , E. Bayraktar - Parametric Finite Element Analysis of square cup deep drawing – computational material science and surface engineering – vol 1, 2009
3. Grebenisan Gavril, Radu I - Finite element analysis of a forming process, USING Static Structural (ANSYS) and ansys LS-DYNA, Annual Session of Scientific Papers “IMT Oradea 2010”, Oradea
4. GAO E., LI H., KOU H., CHANG , LI J., and ZHOU L. - Finite element simulation on the deep drawing oftitanium thin-walled surface part - Rare Metals (2010) 29: 108-113
Published
2016-03-31
How to Cite
Pop, A., Radu, I., & Blaga, F. (2016). FINITE ELEMENT METHOD PARAMETERIZATION OF DEEP DRAWING PROCESS USING A CAD-CAE APPLICATION. Nonconventional Technologies Review, 20(1). Retrieved from http://revtn.ro/index.php/revtn/article/view/90